How to turn on Debug logging for Patching tool?
Written By
Gergely Szalay
How To articles are not official guidelines or officially supported documentation. They are community-contributed content and may not always reflect the latest updates to Liferay DXP. We welcome your feedback to improve How To articles!
While we make every effort to ensure this Knowledge Base is accurate, it may not always reflect the most recent updates or official guidelines.We appreciate your understanding and encourage you to reach out with any feedback or concerns.
Legacy Article
You are viewing an article from our legacy "FastTrack"
publication program, made available for informational purposes. Articles
in this program were published without a requirement for independent
editing or verification and are provided"as is" without
guarantee.
Before using any information from this article, independently verify its
suitability for your situation and project.
Issue
- When we have any kind of issues while using Patching Tool, we can't analyze the problem because we see the same information in the log and in the console too:
The command has failed. Please see the log for details.
- Can we extract more details from the log?
Environment
- Liferay DXP 7.3+
- Patching Tool 3.0.29+
Resolution
- More information in the log is provided by Patching Tool's debug mode, which has been disabled by default in Patching Tool 3.0.29 and above to reduce the log size.
- Patching tool version 3.0.29 and above:
-
To enable the debug logging, you have to create a patching-tool-default.properties file next to your default.properties file and add the following line: enable.debug.logging=true.
- Patching tool version less than 3.0.29:
- debug logging by default is enabled.
Did this article resolve your issue ?