CKEditor is not displaying full source code text
Written By
Pooja Bhambani
How To articles are not official guidelines or officially supported documentation. They are community-contributed content and may not always reflect the latest updates to Liferay DXP. We welcome your feedback to improve How To articles!
While we make every effort to ensure this Knowledge Base is accurate, it may not always reflect the most recent updates or official guidelines.We appreciate your understanding and encourage you to reach out with any feedback or concerns.
Legacy Article
You are viewing an article from our legacy "FastTrack"
publication program, made available for informational purposes. Articles
in this program were published without a requirement for independent
editing or verification and are provided"as is" without
guarantee.
Before using any information from this article, independently verify its
suitability for your situation and project.
Issue
- Steps to reproduce
1. Set CKEditor as an editor for WebContent.
2. Start Liferay DXP 7.3
3. Create a new basic WebContent.
4. Write a long text, with multiple lines so that scroll should be visible.
5. Go to Source code and see we can't scroll until the end.
Expected Behavior: Source code text must be visible.
Observed Behavior: Source code text is not completely visible, and can't scroll until the end.
Resolution
- The observed behavior is a known issue/bug. And it's fixed in fix-pack-2.
- If the hotfix is required for this issue, please create a support ticket requesting hotfix by attaching patch details.
-
Installing Fix Packs and Hotfixes on Liferay DXP will guide to install this hotfix in the respective environment.
Did this article resolve your issue ?