Service access policy changes for System_Default in Liferay 7.3
How To articles are not official guidelines or officially supported documentation. They are community-contributed content and may not always reflect the latest updates to Liferay DXP. We welcome your feedback to improve How To articles!
While we make every effort to ensure this Knowledge Base is accurate, it may not always reflect the most recent updates or official guidelines.We appreciate your understanding and encourage you to reach out with any feedback or concerns.
Legacy Article
You are viewing an article from our legacy "FastTrack"
publication program, made available for informational purposes. Articles
in this program were published without a requirement for independent
editing or verification and are provided"as is" without
guarantee.
Before using any information from this article, independently verify its
suitability for your situation and project.
Issue
- After migrating the services from version 7.0 to the new version 7.3 the service access policy for System_Default has been changed. How it can be configured with version 7.3?
Resolution
-
The same configuration which was in version 7.0 can be found at Control Panel> Security> Service Access Policy> SYSTEM_DEFAULT.
- The System Settings configuration is used to define the configuration at the SAPEntry level (Control Panel> Security> Service Access Policy) by default.
Did this article resolve your issue ?