I cannot publish a Workflow with Error: Unable to parse definition
How To articles are not official guidelines or officially supported documentation. They are community-contributed content and may not always reflect the latest updates to Liferay DXP. We welcome your feedback to improve How To articles!
While we make every effort to ensure this Knowledge Base is accurate, it may not always reflect the most recent updates or official guidelines.We appreciate your understanding and encourage you to reach out with any feedback or concerns.
Legacy Article
You are viewing an article from our legacy "FastTrack"
publication program, made available for informational purposes. Articles
in this program were published without a requirement for independent
editing or verification and are provided"as is" without
guarantee.
Before using any information from this article, independently verify its
suitability for your situation and project.
Resolution
WARNING! The error may happen due to several reasons, the one that follows is only one of the possible scenarios. If the below solution is not applicable to your case or it won't work, please, reach out to Liferay Support by raising a new ticket @
https://help.liferay.com/hc/requests/new.
- When there is a misconfiguration, like a Task or End node disconnected, this message is expected to be displayed.
- You can Save the definition, but before you can Publish it, the nodes need to be connected.
- Please check that all nodes are correctly connected.
Did this article resolve your issue ?
